G2 Measurement

 

 mwa_g2leisure_145x90px

G2 manual and Series 4 electric wheelchair measurement

By using the following instructions to measure your wheelchair, you will be assured that you are ordering the correct chair dimensions and or replacement component dimensions.

 g2_width

 Seat Width

To determine seat width of the G2 manual and Series 4 power wheelchair, please measure from the outside to outside edge of the seat tube as shown in the picture (left). Ensure that the chair is folded out by pushing down and out on each side of the seat panel.  The seat panel measurement will be  slightly less than the actual chair width. eg 46cm wide wheelchair will be 45.5cm.

All width measurements are in centimetres with increments of 3cm.
eg. 40cm, 43cm , 46cm, 49cm,

 

 g2_depth

 Seat Depth

To determine the seat depth of the G2 manually propelled wheelchair and Series 4 powered wheelchair, please measure from the front edge to the rear edge of the seating panel as show in the picture (left).

All measurements are in centimetres with increments of 3cm.
eg. 40cm, 43cm , 46cm, 49cm,

 

 

 Backrest Height

To determine G2 and Series 4 backrest height, please measure from the top of the seat panel to the top front edge of the backrest panel as shown in the photograph (left).
*Please note: Our panels are made in increments of 3cm eg. 40cm, 43cm, 46cm etc.

For backrest heights exceeding 52cm backrest extensions are required. Backrest extensions are made in increments of 10cm, up to a maximum of 40cm.

 g2_height

 Seat Height

To determine the seat height dimension, please measure from the front top edge of the seat panel to the ground in a vertical alignment as shown in the graphic (left).

 g2_heel_to_knee

Knee to Heel Length

To determine knee to heel dimension please measure from the inside edge of the footplate, to the top front edge of seat upholstery, as per the picture (left). Allow for thickness of the seat cushion in your measurement.